Technocoms Digital Satellite Receiver Technocoms Firmware
 |
| Technocoms X 12000 HD Firmware Upgrade |
Technocoms X-12000 HD Software Download
Technocoms X-12000 HD supports Digital Video Broadcasting (DVB), Internet sharing receiver with FTA ,USB, ETHERNET, and Multisystem CA ：Irdeto x-crypt ,Vicaccess dreamcrypt,Cryptoworks,Conax as so on CA system.
Fully DVB-S
MPEG-2 SD decoding
Teletext (VBI & OSD output)
Subtitle (OSD output)
Aspect ratio: 4:3/16:9
Electronic program guide (EPG)
Parental guidance
All channel memory function, Channel Add/Delete function, Check Signal strength
Software upgrade via Rs232
Channel and Program editor
Transport Stream:MPEG-2 TS Specification(ISO/IEC 13818)
Input Rate:Max. 60 Mbit/s
VIDEO:MPEG-2 MP@ML 720576(PAL), 720480(NTSC)
AUDIO:MPEG-1/2 Audio layer 1,2
Video Resolution:4:3 LetterBox, 4:3 PanScan, 16:9
Audio mode:Stereo, Dual channel, Joint stereo, Mono
Audio Sampling Frequency:32/44.1 KHz
Processor:Conexant CX24303133Mhz
FLASH MEMORY: SST 39VF1601 2 Mbytes
SDRAM:8 Mbytes
Input Voltage Range:90Vac ~ 240Vac(SMPS)
Input Frequency Range:50Hz ~ 60Hz
Power Consumption:Max 25W
Standby Power Consumption Protection:Less then or equal to 10W,Separate Internal Fuse, DC Short circuit protection The input shall the lighting protection
TV SCART:CVBS, RGB, Audio L, R out
RCA JACK:CVBS(Yellow) ,Audio L, R(White, Red)
Digital Audio:Optical S/PDIF
RF Modulator:PAL D/K B/G ICH 21-69
Serial Port:RS232C D-Sub Male Type
Slot:1 Smart Card Slot
Local Area Network Ethernet Port (LAN Connectivity).
Software for Technocoms X-12000 HD is available here to download follow the link below to get the firmware file.
Related Receiver Software:- Technocoms X-10000 Software Update
Comments
Post a Comment